User`s guide

134 Chapter 9
Saving and Recalling (File Management)
Saving and Recalling File
Saving and recalling the segment sweep table
Segment sweep table can be saved in the file with CSV (Comma Separated Value) format.
To save segment sweep table on a file, use the following command:
• :MMEM:STOR:SEGM on page 362
Executing the above command will save the segment sweep table for the active channel.
Recalling the file saved using the above command can reproduce the segment sweep table
on the active channel.
To recall the settings from a file, use the following command:
• :MMEM:LOAD:SEGM on page 351
NOTE It is possible to recall a file from a different channel where it was saved. Note that recalling
operation is not guaranteed for the file that might have been modified with editor.
Saving and recalling the limit table
Limit table can be saved in the file with CSV (Comma Separated Value) format. To save
limit table on a file, use the following command:
• :MMEM:STOR:LIM on page 358
Executing the above command will save the limit table for the active trace of the active
channel.
Recalling the file saved using the above command can reproduce the limit table on the
active trace of the active channel. To recall the settings from a file, use the following
command:
• :MMEM:LOAD:LIM on page 348
NOTE It is possible to recall a file from a different channel or trace where it was saved. Note that
recalling operation is not guaranteed for the file that might have been modified with editor.
Saving/loading (importing) the VBA program
Saving
Only the VBA project file can be saved using command.
To save the VBA project that is opened on the VBA editor on the file, use the following
command.
• :MMEM:STOR:PROG on page 359
Loading (importing)
To load the VBA project to the VBA editor, or to import the module/form file, use the
following command.
• :MMEM:LOAD:PROG on page 349
Executing above command will load/import the file according to its extension as follows: