Installation guide

24 Chapter 2
Installation
Starting the E5071C
Figure 2-6 Line switch (Always ON) and power cable receptacle
e5071cqe1003
EXT TRIG
IN
EXT TRIG
OUT
GPIB
115 V
350 VA Max
LINE
- 230 V
50/60 Hz
REF IN REF OUT AUX IN 2 AUX IN 1
WARNING: No operator serviceable
parts inside. Refer servicing to qualified
personnel.
4
LR95111C
N10149
ICES/NMB-001
ISM 1-A
24 BIT I/O
USB
Serial Label
Model# Label
REF OVEN
(10 MHz)
1 V, 10 V10 MHz
PRINTER
(PARALLEL)
VIDEORESERVED
RESERVED
ETHERNET
2
1
4
3
I/O PANEL
Windows Label
Switch must remain
ON while operating.
NOTE
FUSE 0.5 A
PORT 1PORT 2PORT 3PORT 4
BIAS INPUT 35 VDC Max
Power Cable Receptacle
Line Switch: Always ON ( | )
Disconnection from Supply Source
The power supply of the E5071C is cut off by disconnecting the plug of the power cable
(on either AC outlet side or E5071C side). When it is necessary to disconnect the power
supply in order to avoid shock hazards, etc., pull out the power cable plug from either the
AC outlet side or the E5071C side.
NOTE To allow this operation to be performed smoothly, be sure to follow the guidelines in
“Ensuring Adequate Free Space around Analyzer for Immediate Disconnection of Power
Cable in Case of Emergency” on page 16.
When turning the power OFF under normal circumstances, always follow the methods
described in “Turning the Power OFF” on page 23.