User Manual

472 Chapter 5
One-Button Measurement Functions
Meas Setup (Spectrum Emissions Mask—SEM)
One-Button Measurement Functions
Default Terminator: dBc
Range: –200 dBc to 50 dBc
Remote Command:
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier <real number>,[<real
number>]...
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier?
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle OFF|ON|0|1
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle?
Remote Command Notes: Comma separated list of 5 values. n = 1 for BTS and n = 2 for
MS. Default is BTS (1).
Example: SEM:OFFS:LIST:STOP:RCAR –20 dBm
SEM:OFFS:LIST:STOP:RCAR
SEM:OFFS:LIST:STOP:RCAR:COUP 0
SEM:OFFS:LIST:STOP:RCAR:COUP?
5.22.4.11 Fail Mask
Displays the menu to select one of the following logic keys for fail conditions between the
measurement results and the test limits:
Absolute, Relative, Abs AND Rel,andAbs OR Rel.
Absolute
- Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between
Abs Start and Abs Stop, inclusive. This is the
default selection for each offset for BTS measurements.
Relative - Fail is shown if one of the relative spectrum emission mask measurement
results is larger than the limit between
Rel Start and Rel Stop,inclusive.
Abs AND Rel - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between Abs Start and Abs Stop, inclusive AND one of the
relative spectrum emission mask measurement results is larger than the limit for Rel
Start
and Rel Stop. This is the default for MS measurements.
Abs OR Rel - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between
Abs Start and Abs Stop,inclusiveORoneofthe
relative spectrum emission mask measurement results is larger than the limit for
Rel
Start
and Rel Stop.
Key Path:
Meas Setup, Offset/Limits, More
State Saved: Saved in instrument state.
Factory Preset: Dependent upon Radio Standard and device selected, refer to the default