Programming instructions

Programming Examples
LAN Programming Examples
Chapter 264
LAN Programming Examples
• “VXI-11 Programming Using SICL and C” on page 65
• “VXI-11 Programming Using VISA and C” on page 66
• “Setting Parameters and Sending Queries Using Sockets and C” on page 72
• “Setting the Power Level and Sending Queries Using PERL” on page 89
• “Generating a CW Signal Using Java” on page 91
The LAN programming examples in this section demonstrate the use of VXI-11 and Sockets
LAN to control the signal generator. For details on using FTP and TELNET refer to “Using
FTP” on page 25 and “Using TELNET LAN” on page 21 of this guide.
Before Using the Examples
To use these programming examples you must change references to the IP address and
hostname to match the IP address and hostname of your signal generator.