Programming instructions

Getting Started
Using RS-232
Chapter 130
Agilent Technologies <instrument model name and number>, US40000001,C.02.00
Character Format Parameters
The signal generator uses the following character format parameters when communicating
via RS-232:
• Character Length: Eight data bits are used for each character, excluding start, stop, and
parity bits.
• Parity Enable: Parity is disabled (absent) for each character.
• Stop Bits: One stop bit is included with each character.
If You Have Problems
1. Verify that the baud rate, parity, and stop bits are the same for the computer and signal
generator.
2. Verify that the RS-232 cable is identical to the cable specified in Table 1-13.
3. Verify that the application is using the correct computer COM port and that the RS-232
cable is properly connected to that port.
4. Verify that the controller’s flow control is set to RTS-CTS.