Installation guide

Safety Information
Instrument Markings
Chapter 1 3
Instrument Markings
The following markings are used on the signal generator. Familiarize yourself with each
marking and its meaning before operating the signal generator.
The instruction manual symbol. The product is marked with this symbol
when it is necessary for the user to refer to the instructions in the manual.
The CE mark is a registered trademark of the European Community. If
this symbol is accompanied by a year, it is the year when the design was
proven.
The CSA mark is a registered trademark of the Canadian Standards
Association.
The C-Tick Mark is a trademark registered to the Australian Spectrum
Management Agency. This indicates compliance with all Australian EMC
regulatory information.
This symbol is used to mark the on position of the power line switch.
This symbol is used to mark the standby position of the power line switch.
This symbol indicates that the input power required is ac.
This is a symbol of an Industrial Scientific and Medical Group 1 Class A
product. (CISPER 11, Clause 4)