Installation guide

Operation Verification
Check for Error Messages
Chapter 322
Check for Error Messages
1. Check the display to see if the ERR annunciator is turned on.
2. If the ERR annunciator is turned on, review the error messages in the queue by pressing
Utility > Error Info. The first error message in the queue will be shown in the text area of the
display.
Refer to the “Error Messages” guide for further information about specific error messages.
If there is more than one error message (each message will be designated as 1 of n), press
the
View Next Error Message softkey until you have seen all of the messages.
3. When you have resolved all of the error messages, press
Clear Error Queue(s) to delete the
messages.
4. Cycle the power on the signal generator and then restart this procedure until the signal
generator powers on without displaying the ERR annunciator.