Installation guide

Getting Started
Configuring Global Settings
Chapter 210
Configuring Global Settings
Adjusting the Display
You can adjust the LCD display using features such as contrast, brightness, screen saver
mode, and the screen saver delay. You can also toggle features such as inverse video, display
updating in remote mode, and the screen saver on or off.
Contrast and Brightness
Press to decrease the display contrast.
Pressing the decrease contrast hardkey and holding it down causes the display background to
gradually darken in comparison to the text on the display. The minimum contrast setting is
not a completely black display. Some contrast between the background and the text will still
be visible.
Press to increase the display contrast
Pressing the increase contrast hardkey and holding it down causes the display background to
gradually brighten in comparison to the text on the display. If the background does not appear
to change, it is probably set to the maximum contrast.
Press
Utility > Display > Brightness.
This allows for adjustment of the display’s brightness.
Use the arrow keys, numeric keypad, or front panel knob to adjust the display brightness. The
brightness value is set to 50 (maximum brightness) at the factory. The minimum brightness
value is 1.
Inverse Video
Press
Utility > Display > Inverse Video Off On.
This toggles between inverse video mode and normal display mode.
The normal display mode for the signal generator is dark text on a light background. Inverse
video mode is light text on a dark background. Inverse video is a persistent state; it is not
affected by a signal generator preset or power cycle.