Installation guide

Replaceable Parts
Cables for Option 506 Signal Generators
3-67
Option 506 - Option 1EM Overall Cables
(also includes cables for Option UN7, 005, and 001 or 002)
Table 3-24
Reference
Designator
Description Part Number
W10 ribbon cable, J13 of A7 Baseband Generator (Option 001 or Option 002)
to J3 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to P2 of A25 Rear Panel Board
8121-0679
W11 semi-rigid cable, output of the A16 Frac-N (Option UNJ or Option 506)
to input of the A15 Sampler (Option UNJ or Option 506)
- passes through the A19 Daughterboard
E4400-60622
W23
(Option UN7)
flexible cable, J4 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BERDATAIN of the rear panel
8121-0659
W24
(Option UN7)
flexible cable, J5 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BER CLK IN of the rear panel
8121-0659
W25
(Option UN7)
flexible cable, J6 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BER GATE IN of the rear panel
8121-0659
W26
(Option 005)
ribbon cable, A5 10 GB Hard Drive (Option 005)
to P3 of A12 CPU
8121-0685
W27 ribbon cable, J2 of A21 YTO Driver (Option UNJ or Option 506)
to J34 of A23 Motherboard
8121-0644
W28 flexible cable, J3 of A21 YTO Driver (Option UNJ or Option 506)
to PH LK of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0645
W29 flexible cable, J4 of A21 YTO Driver (Option UNJ or Option 506)
to YTO EM of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0645
W30 ribbon cable, J5 of A21 YTO Driver (Option UNJ or Option 506)
to J1 of YTO Interface board
8121-0683
W32 wire cable, J36 of A23 Motherboard
to P4 of A26 Rear Panel LVDS Board (Option 1EM)
8121-0678
W50 semi-rigid cable, output of A14 Extended Frequency Output (Option 506)
to input of AT1 High-Power Mechanical Attenuator (Option UNB)
- passes through the A19 Daughterboard
E4400-60628
W57 ribbon cable, AT1 High-Power Mechanical Attenuator (Option UNB)
to J25 of A23 Motherboard
E4400-20132
W58 semi-rigid cable, output of A13 Output (Option UNB)
to input of the A14 Extended Frequency Output (Option 506)
- passes through the A19 Daughterboard
E4400-60630
W70
a
(Option 1EM)
flexible cable, EXT 1 from the rear panel to EXT 2 of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0654
W71
a
(Option 1EM)
flexible cable, EXT 2 from the rear panel to EXT 1 of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0654