Installation guide

Replaceable Parts
Cables for Option UNJ Signal Generators
3-38
W19 flexible cable, J10 of A10 I/Q Multiplexer (Option 501, 502, 503, 504 or
Option UNJ)
to Q IN of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0641
W20 flexible cable, J9 of A10 I/Q Multiplexer (Option 501, 502, 503, 504 or
Option UNJ)
to I IN of A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0641
W23
(Option UN7)
flexible cable, J4 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BERDATAIN of the rear panel
8121-0659
W24
(Option UN7)
flexible cable, J5 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BER CLK IN of the rear panel
8121-0659
W25
(Option UN7)
flexible cable, J6 of A11 Internal Bit Error Rate Analyzer (Option UN7)
to BER GATE IN of the rear panel
8121-0659
W26
(Option 005)
ribbon cable, A5 10 GB Hard Drive (Option 005)
to P3 of A12 CPU
8121-0685
W27 ribbon cable, J2 of A21 YTO Driver (Option UNJ or Option 506)
to J34 of A23 Motherboard
8121-0644
W28 flexible cable, J3 of A21 YTO Driver (Option UNJ or Option 506)
to A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0645
W29 flexible cable, J4 of A21 YTO Driver (Option UNJ or Option 506)
to A19 Daughterboard
- refer to the connector diagram located on the daughterboard cover
8121-0645
W30 ribbon cable, J5 of A21 YTO Driver (Option UNJ or Option 506)
to J1 of YTO Interface board
8121-0683
W31 flexible cable, J20 of A23 Motherboard
to SWEEP OUT of the rear panel
8121-0658
W32 wire cable, J36 of A23 Motherboard
to P4 of A25 Rear Panel Board
8121-0678
W40 ribbon cable, AT1 Electronic Attenuator (Option 501, 502, 503, 504 or
Option UNJ)
to J25 of A23 Motherboard
8121-6837
W43 semi-rigid cable, output of A13 Output (Option 501, 502, 503, 504 or
Option UNJ)
to input of AT1 Electronic Attenuator (Option 501, 502, 503, 504 or
Option UNJ)
- passes through the A19 Daughterboard
E4400-60625
a. When comparing cables W6 and W7 between a model with Option 506 and a model with either
Option 501, 502, 503, 504, or UNJ, notice that cables W6 and W7 are connected to different (swapped)
ports of the A19 Daughterboard.
Table 3-12
Reference
Designator
Description Part Number