Installation guide

Replaceable Parts
Shipping a Defective Assembly Back to Agilent Technologies
3-4
Shipping a Defective Assembly Back to Agilent Technologies
1. When you receive the rebuilt assembly, be careful not to damage the box in which it was shipped. You will
use that box to return the defective assembly. The box you receive should contain the following:
• the rebuilt assembly
• an exchange assembly failure report
• a return address label
2. Complete the failure report.
3. Place the failure report and the defective assembly in the box. Be sure to remove the enclosed return
address label.
4. Seal the box with tape.
If you are inside the United States, stick the pre-printed return address label over the label that is already
on the box and return the box to Agilent Technologies. (Agilent Technologies pays postage on boxes mailed
within the United States.)
If you are outside the United States, do not use the return address label; instead, address the box to the
nearest Agilent Technologies sales and service office.