Installation guide

Assembly Replacement
A16 Frac-N (Option UNJ or Option 506)
2-38
A16 Frac-N (Option UNJ or Option 506)
Tools Required
•none
Removal Procedure
Refer to Figure 2-19 for this procedure and to the connector/cable diagram located on the card cage.
1. Disconnect the power cord.
2. Remove the outer and inner-side covers. Refer to “Outer and Inner Instrument Covers” on page 2-4.
3. Locate Side-SLOT 4, lift the retention levers, and disconnect the A16 Frac-N (Option UNJ or Option 506)
from the A19 Daughterboard.
4. Slide out the A16 Frac-N (Option UNJ or Option 506).
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Perform the post-repair adjustments and performance tests that pertain to this removal procedure.