Installation guide

Assembly Replacement
Assemblies That You Can Replace
2-3
Assemblies That You Can Replace
• “Outer and Inner Instrument Covers” on page 2-4
• “Front Panel” on page 2-6
• “A1 Keyboard” on page 2-8
• “A2 Display” on page 2-10
• “A2DS1 Display Backlight” on page 2-12
• “A3 Front Panel Auxilary Board” on page 2-14
• “A4 Inverter” on page 2-16
• “A5 10 GB Hard Drive (Option 005)” on page 2-18
• “A6 Power Supply” on page 2-20
• “A7 Baseband Generator (Option 001 or Option 002)” on page 2-22
• “A9 Digital Demodulator (Option 501, 502, 503, 504 with Option 300)” on page 2-24
• “A10 I/Q Multiplexer” on page 2-26
• “A11 Internal Bit Error Rate Analyzer (Option UN7)” on page 2-28
• “A12 CPU” on page 2-30
• “A13 Output” on page 2-32
• “A15 Sampler (Option UNJ or Option 506)” on page 2-36
• “A16 Frac-N (Option UNJ or Option 506)” on page 2-38
• “A17 Synthesizer (Option 501, 502, 503, 504)” on page 2-40
• “A18 Reference” on page 2-42
• “A19 Daughterboard” on page 2-44
• “A19 Daughterboard Cable Removal” on page 2-46
• “AT1 High-Power Mechanical Attenuator (Option UNB) with A28 Reverse Power Protection
(Option 501, 502, 503, 504 or Option UNJ)” on page 2-63
• “A20 Downconverter (Option 501, 502, 503, 504 with Option 300)” on page 2-48
• “A21 YTO Driver (Option UNJ or Option 506) and A22 Coupler (Option 506)” on page 2-50
• “A23 Motherboard” on page 2-52
• “A23BT1 Battery” on page 2-55
• “A24 Line Module” on page 2-56
• “Rear Panel” on page 2-57
• “A26 Rear Panel LVDS Board (Option 1EM) and A27 Rear Panel SMB Board (Option 1EM)” on page 2-61
• “AT1 High-Power Mechanical Attenuator (Option UNB) with A28 Reverse Power Protection
(Option 501, 502, 503, 504 or Option UNJ)” on page 2-63
• “AT1 High-Power Mechanical Attenuator (Option UNB)” on page 2-65
• “AT1 Electronic Attenuator (Option 501, 502, 503, 504 or Option UNJ)” on page 2-67
• “B1 Power Supply Fan” on page 2-71
• “B2 Small Fan” on page 2-73
• “B3 Daughterboard/Card Cage Fan” on page 2-75
• “RF Output Connector” on page 2-77