User`s guide

32 User’s Guide
Signal Studio for WiMAX E4438C Option H13
WiMAX Project Parameters
DLFP Parameters
Set these parameters to build the appropriate DLFP (Downlink Frame Prefix) bits. The
'BSID' and 'Built Frames' values are read from 'WiMAX Specific Parameters' in the Project
View.
DLFP Contents
After configuring the DLFP Parameters, press the “Generate DLFP” button. This creates
the DLFP contents and the result is shown here. The total length is based on the value
specified in 'Built Frames'.
Import & Exit and Cancel Button
• Import & Exit:insert the DLFP sequence from the cursor position on the 'User Bits
Editor', then go back to the 'Data Type Entry' window.
• Cancel: Discard all changes in the window and go back to the 'Data Type Entry' window.
Burst View
Figure 17 Burst View