User`s guide

User’s Guide 25
E4438C Option H13 Signal Studio for WiMAX
WiMAX Project Parameters
Buttons on the Frame View
• Check Parameters verifies whether there is at least one burst in the frame or not and
the bursts don't overflow the frame time duration. If it is ok, a message “Parameters are
fine” is shown on the status bar. Otherwise an error message will be shown. The same
check is automatically done when you click on “Generate.”
• Add Preamble adds a preamble on the current link.
• Add FCH adds a FCH burst. This button exists only for the Downlink.
• Add Burst adds a data burst on the current link.
• Delete Burst deletes the currently selected burst.
• Copy Burst adds a burst that has the same configuration as the currently selected
burst.
• The Move Up arrow swaps the currently selected burst with the one above it in the
table for that link.
• The Move Down arrow swaps the currently selected burst with the one just below it in
the table for that link.