Technical data

2 Operation and Features
Configuring the Remote Interface
38 E364xA User’s and Service Guide
Remote interface operation
Configuring the Remote Interface
This power supply is shipped with both a GPIB (IEEE- 488)
interface and an RS- 232 interface. The GPIB interface is
selected when the power supply is shipped from the factory.
Only one interface can be enabled at a time. To exit the I/O
configuration mode without any changes, press until
the NO CHANGE message is displayed.
• You can set the GPIB address, parity, and baud rate from
the front panel only.
• The current selection is highlighted for emphasis. All
other choices are dimmed.
• The interface selection is stored in the non- volatile
memory, and does not change when power has been
turned off or after a power- on reset (*RST command).
NOTE
During actual CC operation, if a load change causes the voltage limit to be
exceeded, the power supply will automatically crossover to constant
voltage mode at the preset voltage limit and the output current will drop
proportionately.
VOLTage {<voltage>|MIN|MAX} Set the voltage.
CURRent {<current>|MIN|MAX} Set the current.
OUTPut ON Enable the output.
I/O
Config