Technical data

Getting Started 1
Product at a Glance
E364xA User’s and Service Guide 19
4 Display limit key Show the voltage and current limit values on the display and allow
the knob adjustment for setting limit values.
5 Voltage/Current adjust selection key Select the knob control function for voltage or current adjustment.
6 Stored state recall menu Recall a stored operating state from location 1 through 5 and reset
the power supply to the power-on state (*RST command) from the
front panel by selecting RESET from this menu.
7 State storage menu/Local key
[1]
Store up to five power supply states in non-volatile memory and
assign a name to each of the storage locations, or return the power
supply to the local mode from the remote interface mode.
8 View menu/Calibrate key
[2]
View the error codes and the text of the error message, calibration
string, and system firmware revision, or enable the calibration mode.
9 I/O configuration menu/Secure key
[3]
Configure the power supply for remote interfaces, or secure or
unsecure the power supply for calibration.
10 Output On/Off key Enable or disable the power supply output. This key toggles between
on and off.
11 Resolution selection keys Move the flashing digit to the right or left, and adjust the scrolling
speed of the text being displayed in the View menu.
12 Knob Increase or decrease the value of the flashing digit by turning
clockwise or counter-clockwise.
[1] The key can be used as the Local key when the power supply is in the remote interface mode.
[2] You can enable the calibration mode by holding down this key when you turn on the power supply.
[3] You can use it as the Secure or Unsecure key when the power supply is in the calibration mode.
Table 1 - 4 Front panel overview (continued)
No Item Description