Technical data

Remote Interface Reference 3
Status Reporting Commands
E364xA User’s and Service Guide 115
*PSC {0|1}
This power- on status clear command clears the Status Byte
and the Standard Event register enable masks when power
is turned on (*PSC 1). When *PSC 0 is in effect, the Status
Byte and the Standard Event register enable masks are not
cleared when power is turned on.
*PSC?
Query the power- on status clear setting. The returned
parameter is 0 (*PSC 0) or 1 (*PSC 1).
*SRE <enable value>
Enable bits in the Status Byte Enable register.
*SRE?
Query the Status Byte Enable register. The power supply
returns a decimal value which corresponds to the
binary- weighted sum of all bits set in the enable register.
*STB?
Query the Status Byte summary register. The *STB?
command is similar to a serial poll but it is processed like
any other instrument commands.
The *STB? command returns the same result as a serial poll
but the Request Service bit (bit 6) is not cleared if a serial
poll has occurred.
*WAI
Instruct the power supply to wait for all pending operations
to complete before executing any additional commands over
the interface.
The *WAI command is used only in the triggered mode.