User`s guide
Table Of Contents
- Agilent E3632A DC Power Supply
- Table of Contents
- List of Figures
- List of Tables
- 1 Getting Started
- 2 Operation and Features
- Overview
- Constant Voltage Operation
- Constant Current Operation
- Storing and Recalling Operating States
- Programming the Overvoltage Protection
- Programming the Overcurrent Protection
- Remote Voltage Sensing
- Disabling the Output
- System-Related Operations
- Remote Interface Configuration
- GPIB Interface Configuration
- RS-232 Interface Configuration
- Calibration
- 3 Remote Interface Reference
- SCPI Command Summary
- Introduction to the SCPI Language
- Simplified Programming Overview
- Using the APPLy Command
- Output Settings and Operation Commands
- Triggering Commands
- System-Related Commands
- Calibration Commands
- RS-232 Interface Commands
- SCPI Status Registers
- What is an event register?
- What is an enable register?
- SCPI status system
- The Questionable Status register
- The Standard Event register
- The Status Byte register
- Using Service Request (SRQ) and Serial POLL
- Using *STB? to read the Status Byte
- Using the Message Available Bit (MAV)
- To interrupt your bus controller using SRQ
- To determine when a command sequence is completed
- Using *OPC to signal when data is in the output buffer
- Status Reporting Commands
- Halting an Output in Progress
- SCPI Conformance Information
- IEEE-488 Conformance Information
- 4 Error Messages
- 5 Application Programs
- 6 Tutorial
- 7 Characteristics and Specifications
2 Operation and Features
Storing and Recalling Operating States
34 E3632A User’s Guide
To cancel the store operation, let the display time- out
after about three seconds or press any other function key
except
. The power supply returns to the normal
operating mode and to the function pressed.
4 Save the operating state.
The operating state is now stored.
DONE
This message appears on the display for approximately 1
second.
Recalling a stored state
1 Turn on the recall mode.
Memory location 1 will be displayed in the recall mode.
RECALL 1
This message appears on the display for approximately
three seconds.
2 Recall the stored operating state.
Turn the knob to the right to change the displayed
storage location to 3.
RECALL 3
If this setting is not followed within three seconds with
, the power supply returns to normal operating
mode and will not recall the instrument state 3 from
memory.
3 Restore the operating state.
DONE
This message appears on the display for approximately 1
second.
Store
Store
Recall
Recall
Recall