User`s guide
Table Of Contents
- Agilent E3632A DC Power Supply
- Table of Contents
- List of Figures
- List of Tables
- 1 Getting Started
- 2 Operation and Features
- Overview
- Constant Voltage Operation
- Constant Current Operation
- Storing and Recalling Operating States
- Programming the Overvoltage Protection
- Programming the Overcurrent Protection
- Remote Voltage Sensing
- Disabling the Output
- System-Related Operations
- Remote Interface Configuration
- GPIB Interface Configuration
- RS-232 Interface Configuration
- Calibration
- 3 Remote Interface Reference
- SCPI Command Summary
- Introduction to the SCPI Language
- Simplified Programming Overview
- Using the APPLy Command
- Output Settings and Operation Commands
- Triggering Commands
- System-Related Commands
- Calibration Commands
- RS-232 Interface Commands
- SCPI Status Registers
- What is an event register?
- What is an enable register?
- SCPI status system
- The Questionable Status register
- The Standard Event register
- The Status Byte register
- Using Service Request (SRQ) and Serial POLL
- Using *STB? to read the Status Byte
- Using the Message Available Bit (MAV)
- To interrupt your bus controller using SRQ
- To determine when a command sequence is completed
- Using *OPC to signal when data is in the output buffer
- Status Reporting Commands
- Halting an Output in Progress
- SCPI Conformance Information
- IEEE-488 Conformance Information
- 4 Error Messages
- 5 Application Programs
- 6 Tutorial
- 7 Characteristics and Specifications
E3632A User’s Guide XIX
List of Tables
Table 1-1 E3632A options 7
Table 1-2 E3632A accessories 8
Table 1-3 Front panel overview 18
Table 1-4 Rear panel overview 21
Table 1-5 Display annunciators overview 22
Table 3-1 SCPI command summary 71
Table 3-2 Agilent E3632A programming ranges 82
Table 3-3 Power supply state 99
Table 3-4 Bit definitions — Questionable Status register 109
Table 3-5 Bit definitions — Standard Event register 110
Table 3-6 Bit definitions — Status Byte summary register 112
Table 3-7 SCPI confirmed commands 122
Table 3-8 Non-SCPI commands 124
Table 4-1 Execution error messages 130
Table 4-2 Self-test error messages 135
Table 4-3 Calibration error messages 137
Table 6-1 Wire rating 158
Table 6-2 Slew rate 160
Table 7-1 Physical characteristics 168
Table 7-2 Electrical specifications 169
Table 7-3 Supplemental characteristics 171