User`s guide
Table Of Contents
- Agilent E3632A DC Power Supply
- Table of Contents
- List of Figures
- List of Tables
- 1 Getting Started
- 2 Operation and Features
- Overview
- Constant Voltage Operation
- Constant Current Operation
- Storing and Recalling Operating States
- Programming the Overvoltage Protection
- Programming the Overcurrent Protection
- Remote Voltage Sensing
- Disabling the Output
- System-Related Operations
- Remote Interface Configuration
- GPIB Interface Configuration
- RS-232 Interface Configuration
- Calibration
- 3 Remote Interface Reference
- SCPI Command Summary
- Introduction to the SCPI Language
- Simplified Programming Overview
- Using the APPLy Command
- Output Settings and Operation Commands
- Triggering Commands
- System-Related Commands
- Calibration Commands
- RS-232 Interface Commands
- SCPI Status Registers
- What is an event register?
- What is an enable register?
- SCPI status system
- The Questionable Status register
- The Standard Event register
- The Status Byte register
- Using Service Request (SRQ) and Serial POLL
- Using *STB? to read the Status Byte
- Using the Message Available Bit (MAV)
- To interrupt your bus controller using SRQ
- To determine when a command sequence is completed
- Using *OPC to signal when data is in the output buffer
- Status Reporting Commands
- Halting an Output in Progress
- SCPI Conformance Information
- IEEE-488 Conformance Information
- 4 Error Messages
- 5 Application Programs
- 6 Tutorial
- 7 Characteristics and Specifications
XII E3632A User’s Guide
Storing and Recalling Operating States 33
Front panel operation 33
Remote interface operation 35
Programming the Overvoltage Protection 35
Front panel operation 35
Remote interface operation 37
Programming the Overcurrent Protection 38
Front panel operation 38
Remote interface operation 40
Remote Voltage Sensing 41
CV regulation 41
Output rating 42
Output noise 42
Stability 42
Remote voltage sensing connections 43
Disabling the Output 44
Front panel operation 44
Remote interface operation 44
Disconnecting the output using an external relay 45
Knob locking 45
System-Related Operations 46
Self-test 46
Error conditions 47
Display control 48
Firmware revision query 49
SCPI language version 49
Remote Interface Configuration 51
Remote interface selection 51
GPIB address 52
Baud rate selection (RS-232) 52