User`s guide
Table Of Contents
- Agilent E3632A DC Power Supply
- Table of Contents
- List of Figures
- List of Tables
- 1 Getting Started
- 2 Operation and Features
- Overview
- Constant Voltage Operation
- Constant Current Operation
- Storing and Recalling Operating States
- Programming the Overvoltage Protection
- Programming the Overcurrent Protection
- Remote Voltage Sensing
- Disabling the Output
- System-Related Operations
- Remote Interface Configuration
- GPIB Interface Configuration
- RS-232 Interface Configuration
- Calibration
- 3 Remote Interface Reference
- SCPI Command Summary
- Introduction to the SCPI Language
- Simplified Programming Overview
- Using the APPLy Command
- Output Settings and Operation Commands
- Triggering Commands
- System-Related Commands
- Calibration Commands
- RS-232 Interface Commands
- SCPI Status Registers
- What is an event register?
- What is an enable register?
- SCPI status system
- The Questionable Status register
- The Standard Event register
- The Status Byte register
- Using Service Request (SRQ) and Serial POLL
- Using *STB? to read the Status Byte
- Using the Message Available Bit (MAV)
- To interrupt your bus controller using SRQ
- To determine when a command sequence is completed
- Using *OPC to signal when data is in the output buffer
- Status Reporting Commands
- Halting an Output in Progress
- SCPI Conformance Information
- IEEE-488 Conformance Information
- 4 Error Messages
- 5 Application Programs
- 6 Tutorial
- 7 Characteristics and Specifications
3 Remote Interface Reference
Output Settings and Operation Commands
92 E3632A User’s Guide
VOLTage:RANGe {P15V|P30V||LOW|HIGH}
This command selects an output range to be programmed by
the identifier. When 15 V/7 A range is selected, the
maximum programmable voltage and current are limited to
15.45 V and 7.21 A. When 30 V/4 A range is selected, the
maximum programmable voltage and current are limited to
30.90 V and 4.12 A. P30V or HIGH is the identifier for the
0 V/4 A range and P15V or LOW is for the 15 V/7 A range.
At *RST, the 15 V/7 A range is selected.
VOLTage:RANGe?
This query returns the currently selected range. The
returned parameter is P30V (HIGH) or P15V (LOW).
MEASure:CURRent?
This query returns the current measured across the current
sense resistor inside the power supply.
MEASure[:VOLTage]?
This query returns the voltage measured at the sense
terminals of the power supply.