Specifications

Appendix G 613
Messages
Error number: 104
G. Messages
104 Save error
During the saving of file, there was an error detected on the media in which the data is to be
stored. For example, when saving the file into a floppy disk, the space available in the
floppy disk was not sufficient.
Check the space available in the media in which the date is to be stored.
105 Recall error
During reading out (recall) a file, an error has occurred. For example, a file containing
invalid data (such as the extension (.sta) equipment setting files that was saved with a
equipment other than E4991A) has been attempted to read out.
Check to see if there is no problem in the file contents.
106 Invalid file name
During the execution of saving a file/recall command, series of characters showing a file
name were inappropriate. For example, when executing a recall command, file name
extension was incorrect.
Specify an appropriate file name.
Also, when saving data on a floppy disk, this error message will be shown if the disk is not
(properly) inserted or the disk is write-protected.
113 No data trace displayed
Due to the fact that data trace is not being displayed, a command that has been sent was
ignored. For example, during when the data trace is not displayed,
CALC{1-5}:MARK:ON command on page 327 is used in attempt to set the trace which
display a marker as the data trace.
First, use CALC{1-5}:MATH:FUNC command on page 340 to display the data trace.
114 No memory trace displayed
Due to the fact that memory trace is not displayed, a command that has been sent was
ignored. For example, during when the memory trace is not displayed,
DISP:TRAC{1-5}:Y:FOR command on page 366 is used in attempt to set the scale
setting subject as the data trace.
First, use CALC{1-5}:MATH:FUNC command on page 340 to display the memory trace.
118 Segment table empty or insufficient table
Due to the fact that the segment sweep table has not been created, a command that has been
sent was ignored. For example, before the segment sweep table has been created,
SWE:TYPE command on page 515 is used in attempt to set a sweep type as the segment
sweep.
Before carrying out a segment sweep, create the segment sweep table.