Specifications

Appendix G 609
Messages
Error number: 10
G. Messages
10 Cal measure aborted
One of the following problems has occurred.
• During the measurement of necessary calibration/fixture compensation data, or during
and after the calculation of calibration/fixture compensation factors (with calibration
function turned On), setting for calibration/fixture compensation data acquired points
(
Fixed, Full Range, Fixed, User Pwr or User Freq & Pwr) has been altered. All
measured calibration/fixture compensation data acquired thus far, or calibration/fixture
compensation function have been invalidated.
• While the calibration/fixture compensation data acquired point setting is in the user
defined point condition (
User Freq & Pwr), during the measurement of necessary
calibration/fixture compensation data, and during and after the calculation of
calibration/fixture compensation factors (with the calibration function turned On),
sweep condition (Sweep Range, Sweep Parameter, Measurement Points and Sweep
Type) have been altered. All measured calibration/fixture compensation data acquired
thus far, or calibration/fixture compensation function have been invalidated.
• During the measurement of necessary calibration data, the measurement had been
interrupted by
Abort Cal Meas button. The calibration data had been invalidated.
In order to recover the calibration/fixture compensation function or the equipment setting,
which were valid just prior to the event, click
Recover Cal/Compen State button. Also, if
necessary, retry the measurement of calibration/fixture compensation data.
11 Compensation required
Before finishing the measurement of fixture compensation data, a command has been sent
to turn the fixture compensation function On. For example, when during the measurement
of Open Compensation Data has not yet finished,
SENS:CORR2:COLL:OPEN
command on page 451 have been used to attempt setting the Open Compensation Function
in the fixture compensation functions to On.
Measure necessary fixture compensation data.
13 Comp measure aborted
During the measurement of necessary fixture compensation data, the measurement has
been interrupted by
Abort Compen Meas button. The fixture compensation data has been
invalidated.
Retry measuring the fixture compensation data if necessary.
14 Not allowed in power sweep
Invalid command has been sent to the oscillator level sweep while in process. For example,
during the oscillator level sweep,
SWE:TYPE command on page 515 has been used to
attempt setting the sweep type to log sweep. This operation is invalidated during the
oscillator level sweep.
Check to see if the command is valid toward the oscillator level sweep.
15 User cal mode only
Before selecting a user defined calibration kit as the calibration kit, setting has been
attempted by using command defining each standard of the calibration kit.
First, set the calibration kit that will be used as the user defined calibration kit and
afterwards, define each standard rate for the calibration kit that is prepared by the user.