Specifications

Appendix D 597
Table of corresponding 4291B vs. E4991A GPIB commands
Table of Corresponding GPIB Commands
D. Table of corresponding 4291B vs. E4991A GPIB commands
Sets dc bias mode to the current setting mode. SOUR2:CURR:ALC None (Uses SWE:TYPE on page 515 to
set the sweep parameter at DC bias
current sweep. In addition, uses
SEGM:CURR:OFFS:STAT on
page 399 for segment sweep when
setting the fixed current source mode
and
SOUR:CURR:OFFS:STAT on
page 465 for settings other than the
segment sweep.)
Sets the dc bias sweep current center value. SOUR2:CURR:CENT SOUR:CURR:OFFS:CENT on
page 462
Sets the OSC current level sweep center value to the
difference between the marker and the delta marker
values.
None
Sets the OSC current level sweep center value of the
marker.
CALC{1-5}:MARK:SET on page 336
Searches for a peak using the marker and then changes
the CENTER to the OSC current level sweep value of
that peak.
Combines the following commands in
execution.
CALC{1-5}:MARK:FUNC:EXEC on
page 321
CALC{1-5}:MARK:SET on page 336
Sets dc bias current value. SOUR2:CURR SOUR:CURR:OFFS on page 461
Sets the current limit in the dc bias sweep mode. SOUR2:CURR:LIM SOUR:CURR:LIM:OFFS on page 459
Selects the sweep source. SOUR2:CURR:MODE None (Uses SWE:TYPE on page 515
command to set the sweep parameter.)
Sets the OSC current level sweep span value. SOUR2:CURR:SPAN SOUR:CURR:OFFS:SPAN on
page 463
Sets the OSC current level sweep span value to the
difference between the marker and the delta marker
values.
CALC{1-5}:MARK:SET on page 336
Sets the OSC current level sweep span value of the
"OSC level span × zooming aperture".
None (No zooming function for the
sweep span.)
Sets the OSC current level sweep start value. SOUR2:CURR:STAR SOUR:CURR:OFFS:STAR on
page 464
Sets the OSC current level sweep start value of the
marker.
CALC{1-5}:MARK:SET on page 336
Sets the dc bias output ON or OFF. SOUR2:CURR:STAT SOUR:CURR:OFFS:STAT on
page 465
Sets the OSC current level sweep stop value. SOUR2:CURR:STOP SOUR:CURR:OFFS:STOP on
page 466
Sets the OSC current level sweep stop value of the
marker.
CALC{1-5}:MARK:SET on page 336
Sets dc bias mode to the voltage setting mode. SOUR2:VOLT:ALC None (Usec SWE:TYPE on page 515 to
set the sweep parameter at the DC bias
voltage sweep. In addition, uses
SEGM:VOLT:OFFS:STAT on
page 417 for the segment sweep when
setting at the fixed voltage source mode
and
SOUR:VOLT:OFFS:STAT on
page 484 for settings other than the
segment sweep.)
4291B feature 4291B GPIB command E4991A GPIB command