Specifications

592 Appendix D
Table of corresponding 4291B vs. E4991A GPIB commands
Table of Corresponding GPIB Commands
PROGram subsystem:
SENSe subsystem:
Save data arrays that are defined by the
MMEMory:STORe:ITEM:TRACe subsystem
commands.
MMEM:STOR:TRAC Uses the following format to save in a
specified data format.
MMEM:STOR:TRAC on page 391
MMEM:STOR:TRAC:ASC on
page 391
4291B feature 4291B GPIB command E4991A GPIB command
4291B feature 4291B GPIB command E4991A GPIB command
Returns the defined program name. PROG:CAT? The E4991A has a macro function
(E4991A VBA) instead of Instrument
BASIC.
PROG:CAT? on page 394
Creates and downloads program from an external
controller to Instrument BASIC.
PROG:DEF None
Deletes I-BASIC program in the analyzer. PROG:DEL
Deletes all I-BASIC program in the analyzer. PROG:DEL:ALL
Executes the program command. PROG:EXEC
Performs no practical function for the analyzer. PROG:MALL
Define the program name. PROG:NAME PROG:NAME on page 394
Sets or queries the contents of numeric program
variables and arrays in the I-BASIC of the analyzer.
PROG:NUMB None
Sets or queries the state of the program in the analyzer. PROG:STAT PROG:STAT on page 395
Sets or queries the contents of the string program
variables and array of the I-BASIC of the analyzer.
PROG:STR None
Causes no further commands or queries to be executed
until the program in the analyzer exits from the RUN
state.
PROG:WAIT PROG:WAIT on page 395
Creates and downloads program from an external
controller to Instrument BASIC.
PROG:EXPL:DEF None
Deletes I-BASIC program in the analyzer. PROG:EXPL:DEL
Executes the program command. PROG:EXPL:EXEC
Performs no practical function for the analyzer. PROG:EXPL:MALL
Define the program name. PROG:EXPL:NAME
Sets or queries the contents of numeric program
variables and arrays in the I-BASIC of the analyzer.
PROG:EXPL:NUMB
Sets or queries the state of the program in the analyzer. PROG:EXPL:STAT
Sets or queries the contents of the string program
variables and array of the I-BASIC of the analyzer.
PROG:EXPL:STR
Causes no further commands or queries to be executed
until the program in the analyzer exits from the RUN
state.
PROG:EXPL:WAIT
4291B feature 4291B GPIB command E4991A GPIB command
Sets the point averaging factor for the active channel. SENS:AVER1:COUN AVER:COUN on page 288
Sets the point averaging of the active channel ON or
OFF.
SENS:AVER1 AVER on page 287
Resets the averaging and restarts the sweep count at 1 at
the beginning of the next sweep on the active channel.
SENS:AVER2:CLE CALC:AVER:CLE on page 289