Specifications

586 Appendix D
Table of corresponding 4291B vs. E4991A GPIB commands
Table of Corresponding GPIB Commands
Sends the compensation coefficient arrays. DATA CMP{1-3} DATA:CMP{1-3} on page 348
In addition, it is possible to send/read the
array for each segment if the following
command is used.
DATA:SEGM{1-16}:CMP{1-3} on
page 353
Returns the compensation coefficient arrays. DATA? CMP{1-3}
Sends the data array. DATA DATA None (Cannot send/read a data array.)
Returns the data array. DATA? DATA
Sends the raw data array. DATA RAW None (Cannot send a raw data array.)
Returns the raw data array. DATA? RAW DATA:RAW? on page 349
Sends the fixture compensation open standard array. DATA OADM Combining and executing the following
commands makes it possible to
send/read the open standard array (G-B).
SENS:CORR2:CKIT:STAN1:LIST:B
on page 443
SENS:CORR2:CKIT:STAN1:LIST:G
on page 444
Returns the fixture compensation open standard array. DATA? OADM
Sends the fixture compensation short standard array. DATA SIMP Combining and executing the following
commands makes it possible to
send/read out the short standard array
(R-X).
SENS:CORR2:CKIT:STAN2:LIST:R
on page 446
SENS:CORR2:CKIT:STAN2:LIST:X
on page 447
Returns the fixture compensation short standard array. DATA? SIMP
Sends the fixture compensation load standard array. DATA LIMP None (No concept of load compensation
function.)
Returns the fixture compensation load standard array. DATA? LIMP
Sends the level monitor array. DATA MON None (cannot send)
Returns the level monitor array. DATA? MON CALC:DATA:MON? on page 292
(Only the DC bias monitor function is
possible.)
Defines the specified equivalent circuit parameter. DATA {EQC0|EQC1|EQL1|EQR1} CALC{1-5}:DATA:EPAR on page 294
4291B feature 4291B GPIB command E4991A GPIB command