Specifications

Appendix D 585
Table of corresponding 4291B vs. E4991A GPIB commands
Table of Corresponding GPIB Commands
D. Table of corresponding 4291B vs. E4991A GPIB commands
DATA subsystem:
Sets the lower limit value for the segment. CALC:LIM:SEGM:LOW Sets using the following commands.
CALC{1-5}:MARK{1-8}:FUNC:DO
M:LIM:LOW on page 316
CALC{1-5}:MARK:REF:FUNC:DO
M:LIM:LOW on page 330
Sets the midpoint for delta limits. CALC:LIM:SEGM:MIDD None (Cannot set the limit with the
central value and delta value.)
Terminates a limit segment definition. CALC:LIM:SEGM:SAVE None (No need to declare.)
Sets the upper limit value for a limit testing segment. CALC:LIM:SEGM:UPP Sets value with these commands:
CALC{1-5}:MARK{1-8}:FUNC:DO
M:LIM:UP on page 318
CALC{1-5}:MARK:REF:FUNC:DO
M:LIM:UP on page 332
Sets the limit testing ON or OFF. CALC:LIM:STAT CALC{1-5}:MARK:FUNC:DOM:LIM
:ALL on page 314
Returns the available parameters that can be used with
the CALC:MATH1:NAME command.
CALC:MATH1:CAT? None
Sets the thickness of the dielectric material under test. CALC:MATH1:DIM1 CALC:FORM:PAR:DIE on page 300
Sets the size of the toroidal core under test. CALC:MATH1:DIM2 CALC:FORM:PAR:MAG on page 302
Sets the measurement parameter of the active channel,
converting impedance to an admittance, permittivity,
permeability or reflection coefficient.
CALC:MATH1:NAME None
(Can select a measurement parameter
directly using
CALC{1-5}:FORM on
page 298.)
Sets the measurement parameter of the active channel,
converting impedance to an admittance or reflection
coefficient.
CALC:MATH1:STAT
Returns the available parameters that can be used with
the CALC:MATH2:NAME command.
CALC:MATH2:CAT? None
Sets the data math operation. CALC:MATH2:NAME CALC{1-5}:MATH:FUNC on
page 340
(Simultaneously performs the setting of
the calculation function and the on/off
switching. However, the data calculation
function type differs from that of the
4291B.)
Sets data math function ON or OFF. CALC:MATH2:STAT
4291B feature 4291B GPIB command E4991A GPIB command
4291B feature 4291B GPIB command E4991A GPIB command
Defines the following values: the auxiliary part of the
offset value, the gain value of the data math function,
the zooming aperture value as a percentage of the span.
DATA None (No function to set the value.)
Defines the offset values. DATA OFFS CALC{1-3}:MATH:OFFS on page 342
Sets the marker's amplitude value into the offset value. CALC{1-5}:MARK:SET on page 336
Sends the calibration coefficient arrays. DATA CCO{11-33} DATA:CCO{1-6} on page 346
In addition, it is possible to send/read the
array for each segment if the following
command is used.
DATA:SEGM{1-16}:CCO{1-6} on
page 351
Returns the calibration coefficient arrays. DATA? CCO{11-33}