Specifications

584 Appendix D
Table of corresponding 4291B vs. E4991A GPIB commands
Table of Corresponding GPIB Commands
Moves the marker to the peak to the right of the present
marker position.
CALC:EVAL:Y:XPOS:RPE Combines the following commands to
execute.
CALC{1-5}:MARK:FUNC on
page 311
CALC{1-5}:MARK:FUNC:EXEC:RI
GH on page 323
Moves the marker to the next occurrence of the target
value to the right of the present marker position.
CALC:EVAL:Y:XPOS:RTAR
Sets the target value. The target search function moves
the marker to a specific target point on the trace.
CALC:EVAL:Y:XPOS:TARG CALC{1-5}:MARK:FUNC:EXEC on
page 321
Sets the search tracking function. CALC:EVAL:Y:XPOS:TRACK CALC{1-5}:MARK:FUNC:TRAC on
page 325
Sets the measurement parameter. CALC:FORM CALC{1-5}:FORM on page 298
Selects the unit of phase format. CALC:FORM:UNIT:ANGL CALC{1-5}:FORM:UNIT:ANGL on
page 303
Turns the limit test beeper ON or OFF. CALC:LIM:BEEP None (Use the SYST:BEEP on
page 516 command as necessary.)
Sets the limit test beeper. CALC:LIM:COND
Clears all segments in the limit line. CALC:LIM:CLE None
Adds or subtracts an offset from the stimulus values of
the limit line.
CALC:LIM:CONT|:OFFS None (Cannot add an offset to the limit.)
Displays limit lines. CALC:LIM:LINE None (Always indicated.)
Adds or subtracts an offset from the amplitude value of
the limit line.
CALC:LIM:OFFS None (Cannot add an offset to the limit.)
Completes editing the limit table. CALC:LIM:SAVE None (No need to declare.)
Specifies which limit segment in the table to edit. CALC:LIM:SEGM None (Specifies a marker number in the
GPIB command used for creating a limit
table.)
Adds a new segment to the end of the limit table. CALC:LIM:SEGM:ADD Sets a specified marker for a test marker
using the following commands.)
CALC{1-5}:MARK{1-8}:FUNC:DO
M:LIM on page 313
CALC{1-5}:MARK:REF:FUNC:DO
M:LIM on page 329
Sets the stimulus value of a segment. CALC:LIM:SEGM:CONT Moves the markers to a stimulus value
specified by the following commands.
CALC{1-5}:MARK{1-8}:X on
page 338
CALC{1-5}:MARK:REF:X on
page 334
Deletes a limit testing segment. CALC:LIM:SEGM:DEL Sets off the test marker using the
following commands.)
CALC{1-5}:MARK{1-8}:FUNC:DO
M:LIM on page 313
CALC{1-5}:MARK:REF:FUNC:DO
M:LIM on page 329
Sets the limits an equal amount above and below a
specified middle value instead of setting upper and
lower limits separately.
CALC:LIM:SEGM:DELTA None (Cannot set the limit with the
central value and delta value.)
Starts editing the segment. CALC:LIM:SEGM:EDIT None (No need to declare.)
4291B feature 4291B GPIB command E4991A GPIB command