Specifications

Chapter 3 53
Setting Measurement Conditions
Set Display Scale
3. Setting Measurement Conditions
Figure 3-2 Display Scale Parameters
Use the following GPIB commands to set the scale parameters shown in Figure 3-2.
Full Scale DISP:TRAC{1-5}:Y:FULL on page 367
Full Scale/10
*1
DISP:TRAC{1-5}:Y:PDIV on page 368
Top DISP:TRAC{1-3}:Y:TOP on page 372
Bottom DISP:TRAC{1-3}:Y:BOTT on page 365
Ref Pos DISP:TRAC{1-3}:Y:RPOS on page 370
Ref Val DISP:TRAC{1-5}:Y:RLEV on page 369
Ref X DISP:TRAC{4-5}:X:RLEV on page 362
Ref Y DISP:TRAC{1-5}:Y:RLEV on page 369
*1. With the display format set to Linear display or Complex plane, one-tenth of the full-scale
value can be used instead. However, one-tenth of the full-scale does not always correspond
to a grid width (Grid lines are not always displayed at an interval of one-tenth of the
full-scale).