Specifications

Chapter 17 525
GPIB Command Reference
TRIG
17. GPIB Command Reference
TRIG
Format TRIGger[:SEQuence][:IMMediate]
Description The trigger system immediately triggers and executes measurements during the trigger
event detection state. An error will occur if the trigger sequence is not in the trigger event
detection state. (No query)
Front Panel
Equivalents
Unavailable.
TRIG:EVEN
Format TRIGger[:SEQuence]:EVENt[:TYPe] {SWEep|POINt|SEGMent}
TRIGger[:SEQuence]:EVENt[:TYPe]?
Description Selects the detection point of trigger events.
Parameters
Query response {SWE|POIN|SEGM}<newline><^END>
Related commands TRIG:SOUR on page 526
Front Panel
Equivalents
Trigger - Trigger Setup... - Trigger Event
Description
SWEep
*1
(Default)
When a trigger event is detected, a sweep is executed once.
POINt When a trigger event is detected, measurements are carried
out at each measurement point. Therefore, detection of trigger
events must be executed as many times as the number of
measurement points before a sweep is completed.
SEGMent When a trigger event is detected during a segment sweep, the
sweep is executed according to the sweep setting of the
segment. Therefore, the number of detected trigger events
must equal the number of segments before a sweep is
completed for all of the segments of the list sweep table.
*1.When Internal Trigger is selected, SWEep is selected automatically.