Specifications

510 Chapter 17
GPIB Command Reference
SWE:DWEL3
SWE:DWEL3
Format [SENSe:]SWEep:DWELl3 <numeric>
[SENSe:]SWEep:DWELl3?
Description Sets the delay time for each segment in the segment sweep mode. In addition, when
automatic sweep time is set to auto with the
SWE:TIME:AUTO command, the delay time
is reset to 0 second.
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric}<newline><^END>
Related commands SWE:TIME:AUTO command on page 514
Front Panel
Equivalents
Stimulus - Sweep Setup... - Sweep Time: [Auto/Manual] - Segment Delay
<numeric>
Description Delay time
Data type Floating point
Range 0 to 20
Default 0
Resolution 1E-4
Unit s (seconds)