Specifications

Chapter 17 509
GPIB Command Reference
SWE:DWEL2
17. GPIB Command Reference
SWE:DWEL2
Format [SENSe:]SWEep:DWELl2 <numeric>
[SENSe:]SWEep:DWELl2?
Description Sets the delay time for each measurement point. In addition, when automatic sweep time is
set to auto with the
SWE:TIME:AUTO command, the delay time is reset to 0 second.
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric}<newline><^END>
Related commands SWE:TIME:AUTO command on page 514
Front Panel
Equivalents
Stimulus - Sweep Setup... - Sweep Time: [Auto/Manual] - Point Delay
<numeric>
Description Delay time
Data type Floating point
Range 0 to 20
Default 0
Resolution 1E-4
Unit s (seconds)