Specifications

46 Chapter 3
Setting Measurement Conditions
Set Sweep Conditions
DC Bias Voltage Sweep
If dc bias voltage sweep is selected as the sweep parameter, use one of the following GPIB
commands to set the sweep range.
After setting up a sweep range, use the following GPIB command to set the dc bias current
limit maximum value.
• SOUR:CURR:LIM:OFFS on page 459
Use the following GPIB command to turn on or off the dc bias output. When the dc bias
output is turned on from off, the sweep mode is automatically set to hold mode.
• SOUR:VOLT:OFFS:STAT on page 484
DC Bias Current Sweep
If dc bias current sweep is selected as a sweep parameter, use one of the following GPIB
commands to set the sweep range.
After setting the sweep range, use the following GPIB command to set the maximum value
of the dc bias voltage limit.
• SOUR:VOLT:LIM:OFFS on page 478
Use the following GPIB command to turn on or off the dc bias output. When the dc bias
output is turned on from off, the sweep mode is automatically set to hold mode.
• SOUR:CURR:OFFS:STAT on page 465
Sweep parameter Sweep range GPIB command
dc bias voltage sweep Start value SOUR:VOLT:OFFS:STAR on page 483
Stop value SOUR:VOLT:OFFS:STOP on page 485
Center value SOUR:VOLT:OFFS:CENT on page 481
Span value SOUR:VOLT:OFFS:SPAN on page 482
Sweep parameter Sweep range GPIB command
dc bias current sweep Start value SOUR:CURR:OFFS:STAR on page 464
Stop value SOUR:CURR:OFFS:STOP on page 466
Center value SOUR:CURR:OFFS:CENT on page 462
Span value SOUR:CURR:OFFS:SPAN on page 463