Specifications

434 Chapter 17

GPIB Command Reference

SENS:CORR1:CKIT:STAN7:PLF

Format SENSe:CORRection1:CKIT:STANdard7:PLFactor <numeric>

SENSe:CORRection1:CKIT:STANdard7:PLFactor?

Description Defines the dielectric dissipation factor of the Load standard of the calibration kit in

dielectric measurement. This command can be used when Option 002 (material

measurement software) is installed.

Parameters

If the specified parameter is outside the range, the minimum (if the lower limit of the range

is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.

Query response {numeric}<newline><^END>

Related commands SENS:CORR1:CKIT:STAN7:PRE command on page 435

SENS:CORR1:CKIT:STAN7:THIC command on page 436

Front Panel

Equivalents

Stimulus - Cal/Comp... - Cal Kit Menu - εr Loss

Description Dielectric dissipation factor of the Load standard

Data type Floating point

Range -1E6 to 1E6

Default 0