Specifications

Chapter 17 431
GPIB Command Reference
SENS:CORR1:CKIT:STAN3:LIST:R
17. GPIB Command Reference
SENS:CORR1:CKIT:STAN3:LIST:R
Format SENSe:CORRection1:CKIT:STANdard3:LIST:R <numeric 1>,<numeric 2>,..,<numeric
N>
SENSe:CORRection1:CKIT:STANdard3:LIST:R?
Description Defines the resistance value (R) of the Load standard of a user-defined calibration kit by
using the list setting function.
When using the list setting function, the resistance value (R) of the Load standard, defined
for the calibration data throughout the entire frequency range, is set for the exact number of
measurement points (N).
NOTE The standard value defined by using the list setting function can only be used when
measuring the calibration data in the user-defined frequency point/user-defined power
point.
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric 1}, {numeric 2},.., {numeric N}<newline><^END>
Where N is the number of measurement points.
Related commands SENS:CORR1:CKIT:LIST command on page 421
SENS:CORR1:CKIT:STAN3:LIST:X command on page 432
FORM:DATA command on page 374
Front Panel
Equivalents
Unavailable.
<numeric n>
Description Resistance value (R) of the Load standard
Data type Floating point
Range -1E6 to 1E6
Default 50
Unit Ω (ohm)