Specifications

Chapter 17 425
GPIB Command Reference
SENS:CORR1:CKIT:STAN1:LIST:G
17. GPIB Command Reference
SENS:CORR1:CKIT:STAN1:LIST:G
Format SENSe:CORRection1:CKIT:STANdard1:LIST:G <numeric 1>,<numeric 2>,..,<numeric
N>
SENSe:CORRection1:CKIT:STANdard1:LIST:G?
Description Defines the conductance value (G) of the Open standard of a user-defined calibration kit
with the list setting function.
When using the list setting function, the conductance value (G) of the Open standard,
defined for the calibration data throughout the entire frequency range, is set for the exact
number of measurement points (N).
NOTE The standard value defined with the list setting function can only be used when measuring
the calibration data in the user-defined frequency point/user-defined power point.
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric1}, {numeric 2},.., {numeric N}<newline><^END>
Where N is the number of measurement points.
Related commands SENS:CORR1:CKIT:LIST command on page 421
SENS:CORR1:CKIT:STAN1:C command on page 422
FORM:DATA command on page 374
Front Panel
Equivalents
Unavailable.
<numeric n>
Description Conductance value (G) of the Open standard
Data type Floating point
Range -1E6 to 1E6
Default 0
Unit S (Siemens)