Specifications

42 Chapter 3
Setting Measurement Conditions
Set Measurement Parameter
Display Format
Use the following GPIB command to set the display format to Rectangular format:
• DISP:TRAC{1-5}:GRAT:FORM on page 357
If the Rectangular format is selected, the following GPIB command can be used to set the
Y-axis scale to either Liner or Log.
• DISP:TRAC{1-3}:Y:SPAC on page 371
Phase Display for Scalar Trace
When the measurement parameter is phase for a scalar trace, use the following GPIB
commands to set the unit and to turn on/off expanded phase display.
Set Unit
Use the following GPIB command to set the unit (degree or radian) in which phase is
displayed:
• CALC{1-5}:FORM:UNIT:ANGL on page 303
Expanded Phase Display
The following GPIB command can be used to turn on/off the expanded phase display (in
which phases less than -180 degree and more than +180 degree are not folded):
• CALC{1-3}:FORM:PAR:EPH on page 301
εr' DCR
Real part of complex permittivity
*2
εr'' DCLF
Imaginary part of complex permittivity *1
*2
tanδ(ε) DCLT
Dielectric loss tangent
*2
*1. Parameters selectable when the Magnetic Material measurement mode is selected.
*2. Parameters selectable when the Dielectric Material measurement mode is selected.
Table 3-1 Measurement Parameters for Scalar Trace
Measurement
parameter
GPIB
parameter
Description