Specifications

418 Chapter 17
GPIB Command Reference
SEGM:VOLT:STAT
SEGM:VOLT:STAT
Format [SENSe:]SEGMent:VOLTage:STATe {ON|OFF|1|0}
[SENSe:]SEGMent:VOLTage:STATe?
Description When creating the segment sweep table, selects the voltage mode to set the oscillator level.
In addition, use the SEGM{1-16}:VOLT command to set the oscillator voltage level.
Parameters
Query response {1|0}<newline><^END>
Related commands SEGM{1-16}:VOLT command on page 414
SEGM:CURR:STAT command on page 402
SEGM:POW:STAT command on page 412
Front Panel
Equivalents
Stimulus - Sweep Setup... - Segment Table Menu - More - Osc Unit
Description
ON or 1 (Default) Specifies the voltage mode.
OFF or 0
Specifies a mode other than the voltage mode.
*1
*1.When specifying a mode other than the voltage mode, specify either the current mode
or power mode with the SEGM:CURR:STAT command or the SEGM:POW:STAT
command, respectively.