Specifications

Chapter 3 41
Setting Measurement Conditions
Set Measurement Parameter
3. Setting Measurement Conditions
Parameters for Scalar Trace
Measurement Parameters
Table 3-1 shows measurement parameters available for a scalar trace. Use the following
GPIB command to specify a trace number (1, 2, or 3) and select measurement parameters.
Note that up to three measurement parameters can be displayed at a time.
• CALC{1-5}:FORM on page 298
Table 3-1 Measurement Parameters for Scalar Trace
Measurement
parameter
GPIB
parameter
Description
|Z| Z Absolute value of impedance
|Y| Y Absolute value of admittance
Ls LS Equivalent serial inductance
Lp LP Equivalent parallel inductance
Cs CS Equivalent serial capacitance
Cp CP Equivalent parallel capacitance
Rs RS Equivalent serial resistance
Rp RP Equivalent parallel resistance
D D Dissipation factor
Q Q Quality factor (reciprocal of dissipation factor)
R R Serial resistance
X X Reactance
G G Conductance
B B Susceptance
θz ZPH Phase of impedance
θy YPH Phase of admittance
|Γ| RC Absolute value of reflection coefficient
θγ RCPH Phase of reflection coefficient
Γx RCX Real part of reflection coefficient
Γy RCY Imaginary part of reflection coefficient
|μr| P
Absolute value of complex permeability
*1
μr' PRE
Real part of complex permeability
*1
μr'' PLF
Imaginary part of complex permeability *1
*1
tanδ(μ) PLT
Magnetic loss tangent
*1
|εr| DC
Absolute value of complex permittivity
*2