Specifications

406 Chapter 17

GPIB Command Reference

SEGM:DEL:ALL

If the specified parameter is outside the range, the minimum (if the lower limit of the range

is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.

NOTE It is necessary to set the parameters of numeric 6 and numeric 7 when Option 001 (dc bias

function) is not installed or dc bias is not applied to the DUT. In this case, set default values

such as 100uA and 1V to the parameters of numeric 6 and numeric 7, respectively.

Related commands SEGM:CURR:STAT command on page 402

SEGM:POW:STAT command on page 412

SEGM:VOLT:STAT command on page 418

SEGM:CURR:OFFS:STAT command on page 399

SEGM:VOLT:OFFS:STAT command on page 417

Front Panel

Equivalents

Unavailable.

SEGM:DEL:ALL

Format [SENSe:]SEGMent:DELete:ALL

Description Deletes all segments in the segment sweep table. In addition, this GPIB commnad is

unavailable when the sweep parameter is set to segment sweep. (No query)

Front Panel

Equivalents

Unavailable.

Default

voltage:

100E-3

current:

2E-3

power:

-13.01

voltage:

current:

100E-6

current:

2E-3

voltage:

Unit V/A/dBm V/A A/V