Specifications
338 Chapter 17
GPIB Command Reference
CALC{1-5}:MARK{1-8}:X
CALC{1-5}:MARK{1-8}:X
Format CALCulate{1-5}:MARKer{1-8}:X <numeric>
CALCulate{1-5}:MARKer{1-8}:X?
Description Moves the marker to the stimulus value specified on the trace. The stimulus value at the
marker position is read when executing the command by query.
In addition, when the Δ mode is set to on and this command is executed by query, the
stimulus value at the marker position is read in the form of a relative value to the reference
marker
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric}<newline><^END>
Related commands CALC{1-5}:MARK{1-8}:Y? command on page 339
Front Panel
Equivalents
Marker - Marker... - Select Marker (Specifies the marker 1-8)
Marker - Marker... - Stimulus
Sub-block Description
CALCulate{1-5} Specifies the trace number (1 to 5).
MARKer{1-8} Specifies the marker number (1 to 8)
<numeric>
Description Sets the stimulus value (or sets measurement point if the stimulus
range is set to zero span and marker x-axis unit is set to time) at
the marker position.
Data type Floating point
Range Variable depending on the marker x-axis unit and sweep
parameter.
Default Variable depending on the marker x-axis unit and sweep
parameter.
Unit Variable depending on the marker x-axis unit and sweep
parameter.