Specifications

300 Chapter 17
GPIB Command Reference
CALC:FORM:PAR:DIE
Query response With scalar trace:
{Z|Y|LS|LP|CS|CP|RS|RP|D|Q|R|X|G|B|ZPH|YPH|RC|RCPH|RCX|RCY|P|PRE|PLF|P
LT|DC|DCR|DCLF|DCLT}<newline><^END>
With complex trace
{Z|Y|RC|P|DC}<newline><^END>
Related commands MODE command on page 393
Front Panel
Equivalents
Meas/Format - Meas/Format... - Meas Parameter
CALC:FORM:PAR:DIE
Format CALCulate:FORMat:PARameter:DIElectric <numeric>
CALCulate:FORMat:PARameter:DIElectric?
Description Sets the thickness of dielectric material in the dielectric measurement. This command is
available when Option 002 (material measurement software) is installed.
Parameters
If the specified parameter is outside the range, the minimum (if the lower limit of the range
is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.
Query response {numeric}<newline><^END>
Front Panel
Equivalents
Utility - Material Option... - Thickness
<numeric>
Description Thickness of dielectric material
Data type Floating point
Range 1E-6 to 4.8E-3
Default 1E-6
Resolution 1E-10
Unit m (meter)