Specifications

288 Chapter 17

GPIB Command Reference

AVER:COUN

AV ER :C OU N

Format [SENSe:]AVERage:COUNt <numeric>

[SENSe:]AVERage:COUNt?

Description Sets the averaging factor when using the point averaging function. Only setting the

averaging factor does not set the point averaging function to on. Use the

AVER command

to set the point averaging function to on.

In addition, use the SEGM{1-16}:AVER:COUN command to set the point averaging

factor for the segment sweep.

Parameters

If the specified parameter is outside the range, the minimum (if the lower limit of the range

is exceeded) or maximum value (if the upper limit is exceeded) will be assumed.

Query response {numeric}<newline><^END>

Related commands AVER command on page 287

SEGM{1-16}:AVER:COUN command on page 396

Front Panel

Equivalents

Stimulus - Sweep Setup... - Point Average

Description Point averaging factor

Data type Integer

Range 1 to 100

Default 1