Specifications

Chapter 7 145
Measurement Result Processing
Using Marker Function
7. Measurement Result Processing
Defining a Target
The marker’s target search function can be used to search for a specified target. Use the
following GPIB command to specify a target value.
• CALC{1-5}:MARK:FUNC:TARG on page 324
Defining a Peak
The marker’s peak search function searches for the maximum value (positive peak value)
or minimum value (negative peak value) that agrees with the definitions shown in
Figure
7-1. Use the following GPIB command to define peaks.
• CALC{1-5}:MARK:APE:EXC:X on page 307
• CALC{1-5}:MARK:APE:EXC:Y on page 308
The following GPIB command can be used to define a peak based on the stimulus value
and the measurement value at an active marker position.
• CALC{1-5}:MARK:APE:SET on page 306
Figure 7-1 Peak Definition in Marker Search