Specifications

Chapter 6 127
Read and Write Measurement Data
Internal Data Flow
6. Read and Write Measurement Data
Fixture Compensation Data Arrays
The fixture compensation data array contains Open/Short measurement data in the
complex format. This data is used to calculate fixture compensation coefficients. There are
two arrays containing Open/Short measurement data.
Use the following GPIB command to read the fixture compensation data array.
• DATA:CMD{1-2}? on page 347
When the sweep type is set to segment sweep, the following GPIB command can be used
to read the fixture compensation data array for each specified segment.
• DATA:SEGM{1-16}:CMD{1-2}? on page 352
Note that the above GPIB commands can be used to read fixture compensation data arrays
measured with the fixture compensation data measurement points of “User-defined
frequency points” and “User-defined power points.”
Writing the fixture compensation data array is not allowed.
Array
number
*1
Contained data
1 Open measurement data for calculating fixture
compensation coefficients.
2 Short measurement data for calculating fixture
compensation coefficients.
*1. This number corresponds to the number specified at the end of the com-
mand.