Technical data

Installing Agilent I/O Libraries Suite 2
Agilent Connectivity Guide 37
If you see this dialog box, insert the Automation-Ready CD with Agilent
IO Libraries Suite into the CD-ROM drive of your PC. Windows will
use the files on the CD to make repairs.
If you are using Windows Vista or Windows 7 with User Access Control
(UAC) enabled, you may see this dialog box even if the CD is in the
CD-ROM drive. You will be able to browse to the files on the CD, but
you will get the dialog box above again and again when you click OK.
In order to complete the repair in this case, you must do one of the
following two procedures:
• Perform the repair with User Access Control disabled:
1 Close the Windows Installer dialog box (shown above).
2 Disable User Access Control.
3 Restart the PC.
4 Perform the Repair or Modify operation.
5 Enable User Access Control and follow any further instructions
from Windows. (You may be asked to restart your PC.)
• Run the installer from your desktop:
1 Do not close the Windows Installer dialog box shown above.
2 Copy the Installer folder from the Automation-Ready CD with
Agilent IO Libraries Suite to your PC’s desktop.