Technical data

140 Agilent Connectivity Guide
6 Programming Your Instruments
Configure GPIB Card Parameters. With the GPIB interface selected
in the instrument Explorer Pane, click Change Properties... in the
Agilent 82351 PCI GPIB Interface Properties Pane on the right. The
PCI GPIB configuration dialog box appears, as shown below
.
1 Set the GPIB properties as required, referring to the online Help for
specific information on each property as needed. Also, verify that
this is the System Controller for the GPIB to which it is attached (this
is the typical operating mode). (See “System Controller” on
page 56.) Then, click the OK button.
2 Change/Accept the Configuration Values. When the configuration
values displayed are acceptable to you, click the OK button.
Repeat Steps for Other Interfaces. If you have installed more than one
GPIB interface in your test system, repeat the above steps for the
remaining interfaces.
Figure 49 The 82351 Configuration Dialog Box