Installation guide

50 Chapter 2
Installing the IO Libraries
Maintaining Existing IO Libraries
6 When re-installation is complete, the Setup Complete screen
appears. Click Finish to complete the process and then remove
the IO Libraries for Instrument Control CD.
Steps to Remove the IO Libraries
1 Turn the PC ON and close all open applications.
2 Insert the Agilent IO Libraries for Instrument Control CD into the
CD-ROM drive and wait a few seconds for the application to run.
The installer should automatically start when the CD is inserted.
If not, select Start|Run
and type <drive>:setup.exe where
drive is your CD-ROM drive letter.
3 The InstallShield
Ò
Wizard appears to begin the IO Libraries
modification process.