Installation guide

48 Chapter 2

Installing the IO Libraries

Maintaining Existing IO Libraries

7 For any option selected, when the Setup Complete screen appears,

(see the following figure) click

Finish to complete the process

and then remove the IO Libraries for Instrument Control CD.

Steps to Repair the IO Libraries

1 Turn the PC ON and close all open applications.

2 Insert the Agilent IO Libraries for Instrument Control CD into the

CD-ROM drive and wait a few seconds for the application to

run.The installer should automatically start when the CD is

inserted. If not, select Start|Run

and type <drive>:setup.exe

where drive is your CD-ROM drive letter.

3 The InstallShield

Wizard appears to begin the IO Libraries

modification process.